General Description; Technical Features - Extel WECACV 70003 Guide D'installation Et D'utilisation

1.

1. GENERAL DESCRIPTION

Digital keyboard operating with a 9 volt type 6 F22 battery to transfer, by radio (433.92 MHz), fixed length codes,
with 1 to 8 selectable digits. This wireless code keyboard has 9 channels and enables you to control up to 9 devices.
In this case, you have to program 1 code per channel,
channel.

2. TECHNICAL FEATURES

Transmission frequency
Distance
Type of code
Number of channels
Power supply
Consumption
Duration of transmission
Protection standard
3. APPLICATIONS
The keyboard is indicated in all cases when the activation of a device must be code protected: automatic garage door
or gate openers for example. The keyboard, by its design, does not need wiring and can be used outdoors. The front
unit, composed with digits, is fixed with screws (fig. 2). The keyboard, of semi-transparent conductible rubber, is backlit.
The battery is in the housing.
N.B. BURGLAR-PROOF electronic housing. Access to electronics does not enable activating the control.
4. ASSEMBLY INSTRUCTIONS
Remove the cover, keyboard and electronic circuit. Attach the box. Connect the battery and close the box with the
special screws provided. The system is ready (see photos 1 to 4).
5. OPERATION
Once the system is power supplied, you can start programming the codes.
(See diagram on next page).
a.1st use INSTALLATION CODE:
This code enables you to enter programming mode to modify later your access code. It is advisable to modify the
factory pre-set installation code on 999999. For this, choose a new personal code with 6 digits and follow the pro-
cedure on the diagram (next page).
b. Programming ACCESS CODE:
This code keyboard has 9 channels, then you can control up to 9 devices. Each device (automatic garage door or gate
openers, etc.) can be controlled thanks to the access codes you selected (1 code per channel). You have to choose a
code from 1 to 8 digits for each device you want to control (the first digit must be the channel number).
Examples: 18625 for the channel 1 / 2533 for the channel 2 / 36541779 for the channel 3
c. Erasing ACCESS CODE:
If you make a mistake while programming, push CLEAR and wait until the keyboard switches off, then repeat pro-
gramming.
If you want to modify a code, just program a new code on the same channel, the new entered code cancels and
replaces the previous one.
INSTALLATION CODE
You can note your various
codes here
GB
Each code has to start with the number of the selected
433,92 MHz
Approx. 30 m (in free field)
Multipass
9, selectable through the keyboard
type 6F22 9 V alkaline battery
15 μA in standby
Approx. 1 sec.
IP 54
ACCESS CODE
Channel 1:
Channel 2:
Channel 3:
Channel 4:
Channel 5:
http://www.bakonline.net/
CFI EXTEL WECACV 70003 - 11/2011
2.
L1
1 Channel 6:
2 Channel 7:
3 Channel 8:
4 Channel 9:
5
L2
6
7
8
9