Metabo KFM 9-3 RF Notice Originale page 13

- Use an extraction unit and/or air purifiers
- Ensure good ventilation of the workplace and
keep clean using a vacuum cleaner Sweeping or
blowing stirs up dust
- Vacuum or wash the protective clothing Do not
blow, beat or brush
4.3 Special safety instructions for mains
powered machines:
Pull the plug out of the socket before making any
adjustments, changing tools, carrying out
maintenance or cleaning.
Use of a fixed extractor system is recommended.
Always install an RCD with a maximum trip current
of 30 mA upstream. When the machine is shut down
by the RCD, it must be checked and cleaned. See
chapter 10. Cleaning.
4.4 Special safety instructions for cordless
machines:
Remove the battery pack from the machine before
making any adjustments, changing tools,
maintaining or cleaning.
Protect battery packs from water and
moisture!
Do not expose battery packs to fire!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch contacts or short-circuit battery packs!
A slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks out
and comes into contact with your eyes, wash them
with clean water and seek medical attention
immediately!
5. Overview
See page 2.
1 Clamping screws
2 Spindle locking button
3 Additional handle
4 Slide switch
5 Handle
6 Speed adjustment wheel
7 Dust filter *f
8 Electronic signal indicator *
9 Battery pack release button *
10 Capacity indicator button *
11 Capacity and signal indicator *
12 Battery pack *
13 Graduated collar
14 Adjusting ring
15 Scale
16 Knurled screw *
17 Ripping fence*
18 Support surface
19 Screw for fixing the ball bearing stationary seal
ring
20 Ball bearing stationary seal ring
21 Indexable insert
22 Fastening screw
23 Holder for indexable insert
*equipment-specific
6. Commissioning
6.1 For mains powered machines only
Before plugging in, check that the rated mains
voltage and mains frequency, as stated on the
type plate match your power supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
6.2 For cordless machines only
Dust filter
Always fit the dust filter (6) if the surroundings
are heavily polluted.
The machine heats up faster when the dust
filter (6) is fitted. It is protected by the
electronics system from overheating (see Section
11.).
To fit: See illustration A on page 2.
Fit the dust filter (6) as shown.
Removal: Holding the dust filter (6) at the edges,
raise it slightly and then pull it downwards and
remove.
Rotating battery pack
See illustration B on page 2.
The rear section of the machine can be rotated 270°
in 3 stages, thus allowing the machine's shape to be
adapted to the working conditions. Only operate the
machine when it is in an engaged position.
Battery pack
Charge the battery pack (12) before use.
If performance diminishes, recharge the battery
pack.
The ideal storage temperature is between 10°C and
30°C.
Li-Ion battery packs "Li-Power" have a capacity and
signal indicator (11):
- Press the button (10), the LEDs indicate the
charge level.
- If one LED is flashing, the battery pack is almost
flat and must be recharged.
Removing and inserting the battery pack
Removal: Press the battery pack release (9) button
and pull the battery pack (12) downwards.
Inserting: Slide in the battery pack (12) until it
engages.
6.3 Install parallel guide/ripping fence
See illustration on page 2.
1. Place the parallel guide/ripping fence (17) as
shown.
ENGLISH en
13