KRONAsteel PATRICIA Série Guide De L'utilisateur page 12

EN Application sheet
lighting. The long time operation of the cooker
hood lamps may lead to early breakdown of the
lamps and the cooker hood.
The removal and replacement of the lamps and
filters is not included in the warranty service.
HOOD INSTALLATION
INSTRUCTION
Only the specialist has the right to install and
connect the hood to the mains.
You can not start the installation of the hood and
remove the protective film from the stainless steel
hood until you are convinced of the technical con-
dition of the hood by connecting it to the electrical
network and checking all its functions.
To do this, open the package, remove the hood and
place it on a flat surface in such a way that switch
of operating modes is turned towards the inspec-
tor. The hood is then connected to the mains and
being tested.
If it is working properly at all modes, then you
should start installing the hood. If not, contact the
organization where you purchased the hood or the
warranty workshop. Protective film from stainless
steel hoods should only be removed after the hood
has been installed.
We remind you that the height of the hood
above the electric stove should be at least 65
cm, and above the gas stove less than 75 cm.
It is recommended to install this hood together
with one more person.
Before installing the hood, make sure that the wall
on which the hood is hung is competent enough.
To hang the hood and the bracket for securing the
decorative duct, use screws and dowels, which
suit the type of walls in your kitchen (reinforced
concrete, plasterboard, etc). If the screws and
dowels are included in the kit, you should make
sure that they are suitable for the type of wall on
which the hood will be hung.
10
KITCHEN HOODS
Install the hood in the following sequence:
1. It is necessary to make layout marking on the
wall before drilling the holes for wall plugs.
To do the marking apply a template which is
provided together with the cooker hood to the
wall at a desirable height and level it up (see
Pic. 10). Mark the points A, B on the wall, these
points will match the mounting bracket on the
back side of the cooker hood.
2. Drill two holes 8 mm in diameter at the points
A, B. The depth of the holes should match the
length of the wall plugs.
3. Insert wall plugs Ø 8 into the holes.
4. Drive two screws into A, B holes so that the
distance between the wall and the head of the
screw is 5 mm.
5. If the diameter adapter with the non-return
valve is not preinstalled, use two screws 3.5 x
9.5 to install the adapter at the corresponding
place on the top of the cooker hood (see Fig.
10.1).
6. Hang the cooker hood on the screws A, B.
Use the level to check the horizontal align-
ment. If necessary level up the horizontal line
by regulating the height of the right and left
hooks.
7. Remove the grease filters, and mark another
point C on the wall from the inside of the cook-
er hood, as it is shown in the Fig. 10, and take
the cooker hood off the wall.
Drill a hole at the point C, insert a wall plug and
hang the cooker hood back at the points A, B.
8. Fix the cooker hood by driving a 5.5 x 45 screw
into the hole C.
9. If you use the cooker hood in the extraction
mode, mount the exhaust pipe on top of the
diameter adapter. Apply a sealer on the joint
line of the adapter and the pipe before mount-
ing the pipe, and use a fixing ring to fix the pipe
on the adapter (the ring should be purchased