Machine Operation; Pre--Operation; Scrubbing Floors - Tennant T1 Li Manuel Opérateur

For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
OPERATION
EN
ATTENTION: When refilling solution tank always
empty the recovery tank.
ATTENTION: Do not use the recovery tank to fill
the solution tank. Dirt from the recovery tank may
cause damage to the solution pump.
3. Pour an approved low foaming cleaning detergent
into the solution tank according to the mixing
instructions on the bottle.
WARNING: Fire Or Explosion Hazard. Do Not
Use Flammable Materials. Only Use Commercially
Available Floor Cleaners intended for machine
application.
ATTENTION: Only use Tennant approved cleaning
detergents. Machine damage due to improper
detergent usage will void the manufacturer's
warranty.
4. Replace the full solution tank into machine.
Submerge the solution tank screen into solution
and close the cover (Figure 7).
FIG. 7
8
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE- -OPERATION
1. Make sure battery is charged.
2. Sweep and dust-mop the floor.
3. Place wet floor signs as needed.

SCRUBBING FLOORS

FOR SAFETY: Before operating machine, place wet
floor signs as needed.
WARNING: Fire or Explosion Hazard, Do Not
Use or Pick Up Flammable Materials.
WARNING: Spinning Brush. Keep Hands
Away.
1. Pull the handle adjustment lever and adjust the
handle to a comfortable operating height (Figure 8).
Release the lever to lock the position.
FIG. 8
2. Lower the scrub head to the floor by stepping on
the transport release pedal (Figure 9).
FIG. 9
Tennant T1 Li (09- -10)