2.8
Completing the setup of the boundary wire
Having outlined your garden with the boundary wire, you are now
able to finish up the boundary wire setting.
OUT WIRE
IN WIRE
Repeat Step 1.2 to lead the boundary wire to the charging base.
90
o
Then cut the wire to a length that's appropriate for reaching the
terminal on the charging base, and strip the end of the boundary
wire off.
Connect the wire to the OUT-wire terminal (Red), and fit the
terminal cover back on.
NOTE: The boundary wire must not be crossed when
connecting to the charging base. The right-hand wire end must
IN
OUT
15
be connected to the IN-wire terminal on the charging base and
the left-hand wire end to the OUT-wire terminal.
EN
NOTE: The extended boundary wire should not be too long or
it may cause signal problem. Make sure the wire is straight and
tight all throughout.