Installing The Mini-Bowl And Mini-Blade - KitchenAid KFP0924 Mode D'emploi

aSSEMblINg ThE FOOd PROCESSOR
Install the work bowl cover, being sure
3
it locks into place.

Installing the mini-bowl and mini-blade

Place the mini-bowl inside the work
1
bowl over the power shaft. Rotate the
mini-bowl until the tabs on the top edge
of the bowl drops into the indents on
the top of the work bowl.
Install the work bowl cover, being sure
3
it locks into place.
Insert the drive adapter into the mini-
2
blade, and place on the power shaft. It
may be necessary to rotate the blade
until it falls into place. Press down firmly
to lock it into place.
To remove the mini-bowl after
4
processing, remove the mini-blade by
pulling straight up on the cap. Then lift
the bowl straight up and out, using the
two finger grips located along the top
edge of the bowl.
11