Assembling Your Tilt-Head Stand Mixer - KitchenAid KSM150PSCH0 Mode D'emploi

ASSEMBLING YOUR TILT-HEAD STAND MIXER

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in death,
fire, or electrical shock.
To Remove Bowl
1. Turn speed control to OFF.
2. Unplug stand mixer or disconnect power.
3. Tilt motor head back.
4. Turn bowl counterclockwise.
To Attach Flat Beater, Wire Whip, or Dough Hook
1. Turn speed control to OFF.
2. Unplug stand mixer or disconnect power.
3. Tilt motor head back.
4. Slip beater onto beater shaft and press upward
as far as possible.
5. Turn beater to right, hooking beater over pin on shaft.
6. Plug into a grounded 3 prong outlet.
To Remove Flat Beater, Wire Whip or Dough Hook
1. Turn speed control to OFF.
2. Unplug stand mixer or disconnect power.
3. Tilt motor head back.
4. Press beater upward as far as possible and turn left.
5. Pull beater from beater shaft.
Off
To Attach Bowl
1. Turn speed control to OFF.
2. Unplug stand mixer or
disconnect power.
3. Tilt motor head back.
4. Place bowl on bowl
clamping plate.
5. Turn bowl gently into
clockwise direction.
6. Plug into a grounded
3 prong outlet.
9
On
Pin