Onkyo HTP-993THX Mode D'emploi page 4

Specifications
■
Powered Subwoofer (SKW-980: North American and Asian
models/SKW-938: European models)
Type Acoustic suspension
Rated output power (FTC) 125 watts minimum continuous power,
6 ohms, driven at 100 Hz with a
maximum total harmonic distortion of
1% (SKW-980)
Rated output Power (IEC) 125 watts minimum continuous power, 6
ohms, driven at 100 Hz with a maximum
total harmonic distortion of 1% (SKW-938)
Input sensitivity/impedance 280 mV/20 k
Frequency response 20 Hz to 100 Hz
Cabinet capacity 49 L (1.73 cubic feet)
Dimensions (W H D) 380 mm 444 mm
14-15/16"
(incl. grille and projection)
Weight 15.5 kg (34.2 lbs.)
Drivers unit 30 cm (12") Cone Woofer
Power supply AC 120 V, 60 Hz (SKW-980: North
American)
AC 220 V-230 V, 50/60 Hz (SKW-980:
Asian)
AC 230 V, 50 Hz (SKW-938)
Power consumption 140 W (SKW-980)
137 W (SKW-938)
Grille Fixed
Other Auto Standby function
Non-magnetic shielding
■
Front Speakers (SKF-980)
Type 2 Way Acoustic suspension
Impedance 8
Maximum input power 130 W
Sensitivity 83 dB/W/m
Frequency response 50 Hz to 45 kHz
Crossover frequency 2 kHz
Cabinet capacity 7.5 L (0.265 cubic feet)
Dimensions (W H D) 158 mm × 433 mm × 199 mm
6-1/4" 17-1/16"
(incl. grille and projection)
Weight 5.3 kg (11.7 lbs.)
Drivers unit 12 cm (5") A-OMF Cone Woofer
2.5 cm (1") Soft Dome Tweeter
Terminal Binding post (Banana type supported)
Other Magnetic shielding
■
Center Speaker (SKC-980)
Type
Impedance
Maximum input power
Sensitivity
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W
Weight
Drivers unit
Terminal
Other
429 mm
17-1/2" 16-7/8" ■
Surround Speakers (SKR-980)/
Surround Back Speakers (SKB-980: HTP-993THX/SKS-
HT993THX only)
Type
Impedance
Maximum input power
Sensitivity
Frequency response
Crossover frequency
Cabinet capacity
Dimensions (W
Weight
Drivers unit
Terminal
Other
Specifications and appearance are subject to change without prior
notice.
THX and the THX logo are trademarks of THX Ltd. which may be
7-13/16"
registered in some jurisdictions. All rights reserved.
2
1
2 Way Acoustic suspension
8
130 W
83 dB/W/m
50 Hz to 45 kHz
2 kHz
7.5 L (0.265 cubic feet)
H D) 433 mm 158 mm 199 mm
17-1/16" 6-1/4" 7-13/16"
(incl. grille and projection)
5.3 kg (11.7 lbs.)
12 cm (5") A-OMF Cone Woofer
2.5 cm (1") Soft Dome Tweeter
Binding post (Banana type supported)
Magnetic shielding
2 Way Acoustic suspension
8
130 W
81 dB/W/m
50 Hz to 45 kHz
2 kHz
4.6 L (0.163 cubic feet)
H D) 200 mm 275 mm 169 mm
7-7/8" 10-13/16" 6-5/8"
(incl. grille and projection)
3.5 kg (7.7 lbs.)
13 cm (5-1/8") A-OMF Cone Woofer
2.5 cm (1") Soft Dome Tweeter
Binding post (Banana type supported)
Non-magnetic shielding
En-4
Use with a TV set
In general, Braun tubes used for color television sets, etc.
are extremely sensitive and can be affected even by the
magnetism of the earth. If a speaker system is used near
them, therefore, discoloring or distortion of pictures will
occur.
For magnetic shielded speakers (Front speakers, Center
speaker):
2
1 The speakers are shielded to prevent discoloration. In some
situations, however, discoloration may still be an issue, in
which case you should turn off your TV or monitor, wait 15 to
30 minutes, and then turn it back on again. This normally
activates the degaussing function, which neutralizes the
magnetic field, thereby removing any discoloration effects. If
discoloration problems persist, try moving the speakers
away from your TV or monitor.
For non-magnetic shielded speakers (Powered
subwoofer, Surround speakers, Surround back
speakers):
Try moving the speakers away from your TV or monitor. If
discoloration should occur, turn off your TV or monitor, wait
15 to 30 minutes, and then turn it back on again. This
1
1
normally activates the degaussing function, which
neutralizes the magnetic field, thereby removing any
discoloration effects.