Setting And Modification Of The "Egg Timer; Setting And Modification Of The Cooking Time Of A Heating Zone - BORETTI BKK-97 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Switch off the extension zone
Action
Stop
Saving the concentric heating zone function
The software remembers the last switching state of each zone (small or big diameter). After
switching on the cooking zone again, the last state will be activated, if the extension zone is
activated or not.
Timer
The timer is able to be used simultaneous with all 4 heating zones and this with different time
settings (from 0 to 99 minutes) for each heating zone.

Setting and modification of the "Egg Timer"

The "Egg Timer" is independent from the heating zones. If this timer is on and you stops the
hob, the "Egg Timer" will continue until the end of the time.
Action
To start:
To select the "Egg Timer" press once on timer key
Decrease the time
Increase the time
When the time reaches [00.] it is blinking and beeping.
To stop the "Egg Timer"
Action
To select the "Egg Timer" press once on timer key
To stop the "Egg Timer"

Setting and modification of the cooking time of a heating zone

Action
To select a heating zone
To select the power level
To select the « Timer »
Decrease the time
Increase the time
The time is configured and the cooking starts until the time reaches [00].
50
BKK-97 handleiding 2008.indd 50
Control panel
touch the key [
]
touch the key [-] or [+] [1] to [9]
Control panel
touch the key [0/I]
[-] and [+] simultaneously
press on timer key [-]
press on timer key [+]
Control panel
[-] and [+] simultaneously
press on timer key [-]
press second time on
timer key [-] displays [00]
Control panel
press on key [+]
press on key [+] or [-]
press on timer key [-] and [+]
simultaneously until the
desired heating zone
press on timer key [-]
press on timer key [+]
Display
extension zone control light is blinking
Display
[0]
[00]
[30] wents to 29,28,...
the time increases...
Display
the time displays
displays [01]
Display
[4]
[1] to [9]
timer control light
from the desired
heating zone is on
[30] wents to 29,28,...
the time increases...
17-07-2008 16:58:28

Publicité

Table des Matières
loading

Table des Matières