UPPAbaby PiggyBack Mode D'emploi page 2

PIGGYBACK RIDE-ALONG BOARD
(2) Clamshell Mounts
INSTALLATION
STEP 1: ATTACHING CLAMSHELL MOUNTS Position clamshell mount under interior wheel hub and
squeeze shut until an audible "click" is heard. Repeat on other side. NOTE: Tab
for easier removal.
STEP 2: ATTACHING LATCH Unsnap button on back
of stroller basket to expose aluminum bar. Snap latch
over aluminum bar and rotate down. Re-snap basket
over center opening of latch.
UPPAbaby PiggyBack Instruction Manual
PARTS LIST
Latch
should face back of stroller
STEP 3: ATTACHING PIGGYBACK With Piggyback
attachments facing up, place over clamshell mounts
and slide down into place until an audible "click" is
heard on both sides.
PIGGYBACK RIDE-ALONG BOARD
PiggyBack
STORING PIGGYBACK WHEN NOT IN USE
Lift Piggyback up and snap into latch.
STEP 1: REMOVING PIGGYBACK
Pull out and slide Piggback
attachment up to release.
Repeat on opposite side.
WARNINGS
FAILURE TO FOLLOW THESE WARNINGS AND INSTRUCTIONS COULD RESULT
IN SERIOUS INJURY OR DEATH. READ ALL INSTRUCTIONS BEFORE USE:
NEVER
leave child unattended on this product.
• For use with UPPAbaby CRUZ/ALTA strollers only.
• Periodically check PiggyBack attachment to stroller by lifting up PiggyBack board and checking hinges.
• Maximum Weight Limit: 50 lbs. (22.7 kg).
STORAGE
RELEASING PIGGYBACK FROM LATCH
Press latch down with hand or foot to release
Piggyback.
REMOVAL
STEP 2: REMOVING LATCH STEP 3: REMOVING CLAMSHELL
MOUNTS Push tab out to release
Rotate latch up and remove from
aluminum bar. from wheel hub. Repeat on other
side.
UPPAbaby PiggyBack Instruction Manual