Working Instructions; Checking The Air Pressure; Overload Fuse; Cleaning - ULTIMATE SPEED UMK 10 B2 Instructions D'utilisation Et Consignes De Sécurité

Start-up / Operation / Cleaning / Storage / Warranty and service information
Note: Air may escape from the valve of the inflat-
able when removing the connection valve
not to remove the connection valve
The manometer is not calibrated. Therefore seek
a specialist facility with a calibrated device after
inflating inflatables where incorrect pressure can
be dangerous (e.g. car tyre).
Operation

Working instructions

This device is not suitable for continuous operation.
It was developed to produce air pressure, not air
volume.
For large devices, do not use the device longer
than 5 minutes without interruption to prevent
overheating and damage to the device. After-
wards allow to cool for a minimum of 20 minutes.
We recommend first inflating large products with
air to then produce the desired pressure with
the device.
If your car tyre requires a pressure over 3 bar,
do not use the device longer than 3 minutes
without interruption. Afterwards allow to cool
for a minimum of 20 minutes.

Checking the air pressure

Note: The device does not need to be connected
to the cigarette lighter to test air pressure.
Connect the connection valve
Read the air pressure on the display of the
manometer .
2
Remove the connection valve (see "Startup").
Note: The manometer is not calibrated.

Overload fuse

In the event of overuse or malfunction the overload
fuse in the cigarette lighter plug
11
113044_uls_Mini-Kompressor UMK 10 B2_Content_FI_SE_DK_BE_NL.indd 9
protect the device. Replace the fuse after resolving
. Be sure the reason for the fuse tripping (see „Spare parts /
7
too quickly. accessories") (see Fig. D).
7
Unscrew the tip of the cigarette lighter plug
and remove the overload fuse.
Insert the new overload fuse and reattach the
tip of the cigarette lighter plug.
Never use a fuse with a higher tripping
current. There is a fire hazard!

Cleaning

Do not spray the device with water or
immerse in water. Risk of injury due
to electric shock if moisture enters the
device.
Do not use cleaners or solvents. These could
damage the device beyond repair.
Keep the vents
clean.
Clean with a damp cloth or a brush.

Storage

Keep the device in a dry location and outside
the reach of children.
Be sure not to kink the power cable
air hose
Warranty and service
(see "Startup").
7
information
Creative Marketing Consulting GmbH
warranty
Dear customer,
the warranty for this device is 3 years from the date
of purchase. In the event of product defects, you
have legal rights against the retailer of this product.
Your statutory rights are not limited in any way by
will trip to our warranty detailed below.
5
and the housing of the device
3
to prevent damage.
9
5
and the
4
GB/IE 9
11.06.15 16:55