Care And Maintenance; Battery Installation; Main Unit; Chest Belt - Topcom Speedopulse 1000w Manuel De L'utilisateur

TOPCOM Speedopulse 1000w
5

CARE AND MAINTENANCE

Never use force to open the case or backside cover. DO NOT expose the unit to
extreme weather conditions or cleaning agents and solvents. Avoid dropping or rough
handling of the unit. Clean the device with a dry soft cloth or a soft cloth moistened
with water and mild detergent. Store the device in a dry place when not in use.
Take care of you chest belt. Wash the chest belt with water. Let it dry naturally,
avoiding putting the chest belt under the environment of high temperature or touching
the corrosive as strong acid or alkalis material.
6

BATTERY INSTALLATION

6.1

MAIN UNIT

6.2 FORK MOUNTED TRANSMITTER
+
6.3

CHEST BELT

4
Remove the battery cover from the bottom of the Main Unit
using a small coin. Install the 3 V battery (included in the
packaging) with the positive (+) pole facing the battery cover
and replace the cover.
Main Unit Battery: CR2032 (3V)
Remove the battery cover from the top of the Main Unit using a small
coin.
Install the 12 V battery (included in the packaging) in the transmitter
with the positive (+) pole facing the battery cap. Re-install the cap
with a small coin. Be sure it is sealed correctly to ensure water
resistance
Transmitter Battery: 12V/ VR22 / L1028 / A23
Remove the rubber pad.
Remove the battery cover by using a screwdriver.
Insert the 12V-battery (included in the packaging)
in the transmitter as per diagram. The positive(+)
pole should point to the CE mark.
Replace the metal cover with a screwdriver and
then attach the adhesive rubber plate on top of it.
Chest Belt Battery: 12V/ VR22 / L1028 / A23