Maintenance And Cleaning - Knick MemoRail A1401 Mode D'emploi

Typical Wiring for PCS
3. Outputs externally supplied through process control system / A1401_-P1-4...
(+ connected)
Memosens cable
Green
Yellow
Brown
White
Shield
Notes on wiring (all wiring configurations):
The voltage applied to the rail bus connector is also available
at terminals 1.1 and 1.2.
Wiring has to be suitable for a temperature of min. 75 °C.
Class I Div. 2: Observe Control Drawing 270.000-130 (see "Certificates")
Calibrating Memosens Sensors
Sensors should only be calibrated by qualified staff, as an improperly performed
calibration may cause larger measurement errors than not performing a
calibration.
Calibration can be done using the Knick MemoSuite Advanced and MemoSuite
Basic software packages.

Maintenance and Cleaning

Not necessary for this device.
PCS
Power supply
9