Knick SE 604-MS Mode D'emploi page 9

WARNING! Failure to observe this warning may result in serious
injury. The warning symbol on the rating plate means: Read these
instructions for use, observe the Specifications, and follow the
Safety Instructions.
1. Safety Instructions
1.1. All Applications – All Sensor Variants
Hazards due to pressure, temperature, aggressive media or explo-
sive atmosphere are possible, depending on the location of use.
Therefore, the installation, operation, and servicing of the sensor
shall only be carried out by suitably trained personnel authorized by
the operating company.
1.2. Hazardous Areas – Sensors with Memosens Connector
Comply with all applicable local codes and standards for the installa-
tion of electrical equipment in hazardous locations. For orientation,
please refer to IEC 60079-14, EU directives 2014/34/EU and 1999/92/
EC (ATEX), NFPA 70 (NEC), ANSI/ISA-RP12.06.01. The electrical and
thermal parameters of the sensors must be adhered to.
Memosens Ex sensors are marked by an orange-red ring. Combined
with a model CA/MS-***X** or model CA/MS-***X**-L measuring
cable or a certified measuring cable which is identical in hardware
and function, the sensor may be connected to a suitable measuring
device, as described in the Certificates BVS 15 ATEX E141 X and IECEx
BVS 15.0114X.
User Manual
9