Waterpik WP-100 Mode D'emploi page 7

Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure
setting No. 10), point the handle and tip into sink.
Turn unit ON (I) until water flows from the tip. Turn
unit OFF (O).
High
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the
unit to the lowest setting (pressure setting No. 1)
for first-time use. Gradually increase pressure over
time to the setting you prefer – or as instructed by
your dental professional.
Low
Recommended Technique
For best results, start with the back teeth and work
toward the front teeth. Glide tip along gumline and
pause briefly between teeth. Continue until you
have cleaned the inside and outside of both the
upper and lower teeth.
Lean over sink.
Direct the stream at
a 90-degree angle
to your gumline with
tip in mouth. Slightly
close lips to avoid
splashing, but allow
water to flow freely from
mouth. Set pressure at
desired setting and turn
the unit ON (I). Begin cleaning.
Pause Control
You can temporarily
stop the flow any time by
pressing the pause button
on the handle.
When Finished
Turn the unit OFF (O). Empty
any liquid left in the reservoir.
Unplug the unit.
NOTE: If you used mouthwash or other solution
besides water, see "Using Mouthwash and Other
Solutions" section.
7
ON