Installation Regulations; Health And Safety; The Machine And The Pellets; Stove Components - klover DEA PLUS Manuel D'installation Et De Maintenance

THE SOLUTIONS SUGGESTED FOR INSTALLATION. ALL THE SAFETY STANDARDS CONTAINED IN THE SPECIFIC LAW IN FORCE OF THE
STATE WHERE THE THERMO STOVE IS INSTALLED MUST BE RESPECTED.
EXTRAORDINARY MAINTENANCE MUST ONLY BE PERFORMED BY AUTHORISED AND QUALIFIED STAFF.
For the validity of the warranty, the user must comply with the indications contained in this guide and in particular:

Use the stove according to its operational limits;

All maintenance must be performed constantly;

Only authorise expert and competent people to use the stove.
Failure to comply with the requirements of this guide makes the warranty automatically void.

Installation Regulations

These operating and instructions cover the basic principles to ensure the correct installation of the pellet stove, although particulars may need modification
to reflect local site conditions. In all cases the installation must comply with current Building Regulations, Local Authority By-laws and other regulations that
affect the installation of the stove.
The Building Regulations requirements can be met by adopting the relevant recommendations given in British Standards BS 8303, BS 6461 and BS 7566
as an alternative means to achieve an equivalent level of performance to that obtained by following the guidance given in Approved Document J.

Health and Safety

Care must be taken when installing a Klover pellet stove to ensure that the requirements of the Health and Safety at Work Act are met.
Handling
Adequate facilities must be available for loading, unloading and site handling the appliance bearing in mind the weight of the appliance.

THE MACHINE AND THE PELLETS

Stove components

The stove is delivered with the following equipment:

ONE USE, INSTALLATION AND MAINTENANCE GUIDE;

ONE WARRANTY COUPON;

ONE POWER SUPPLY CABLE.
This manual is integral part of the machine, if the stove is transferred, it is mandatory to give it to the new purchaser.
ROOM TEMPERATURE
PROBE
AIR INTAKE PIPE
MASTER SWITCH
ATTACHMENT FOR
POWER SUPPLY
CABLE AND 2
INCORPORATED
FUSES (4A 250V)
3
FLUE
EXHAUST
ROOM THERMOSTAT
CONNECTION CLAMP
PELLET TANK SECURITY
THERMOSTAT MANUAL
RESET