WAGNER HT400 Guide D'utilisation page 7

Bending Plastic Pipe
Heat all around the pipe from a distance of 2 to 6 inches. Continue heating until the pipe feels
soft and can be bent with little resistance. Hold the bent pipe until it is cold. Overbend the pipe
a little because it will spring back some after release.
Shrink Wrapping
Wrap the object with heat-shrinkable plastic film. Begin to heat the film from a safe distance
while keeping the hot tool moving. Move the hot tool closer to the film until the film starts to
shrink and becomes taut.
Shrink Tubing
The shrink tube accessory can be used whenever circular airflow is required. It is often used to
shrink the tubing around electrical connections, or to soften a plastic tube that must be bent at
a specific location. (See Bending Plastic Pipe). The shrink tube accessory (part number 0503153)
can be purchased by calling 1-800-727-4023.
IMPORTaNT: The shrink tube attachment becomes very hot during use. allow the
attachment to cool before removal or storage.
Slide the shrink tube attachment over the nozzle of the heat tool. Use this attachment
only to shrink tubing. attach only when the heat tool is cool to touch.
7
English