Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Included in the accessories supplied with this machine are 2
inlet hoses and 4 rubber washers. The straight end of these
hoses should be connected to the supply (fig. 1).
The 90° angled end of these hoses should be connected to
the inlet valves on the back of the machine, using one of the
washers to make a water tight seal on each connection.
The couplings should be tightened by hand, a tool should only
be used if a leak occurs.
Do not use excessive force (see fig. 1).
Repair or replacement of a part should be made only by a
qualified service technician to prevent personal injury or damage
to the machine. inlet valves are color coded:
Red
White = Cold
Note:
Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates on the
hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts, wear or leaks are found.
You should carefully position the drain hose to avoid kinks and
ensure proper drainage of the water (fig. 2-3-4-5).
The outlet end of the drain hose must be at least 25" (62 cm)
above the base of the machine. At this point it is possible for
the water to be discharged into a sink or drain pipe, but an air
break must be available at this 25" height to prevent the machine
from syphoning (see fig. 2-3 aside).
No more than 6" of the drain hose should be inserted in the
drain pipe.
IMPORTANT
make sure that the drain hose is not kinked and the water flow
has not been restricted.
Standpipe drain system:
In RV installation needs a 1-1/2 inch (3.7 cm) diam.
standpipe with minimum carry away capacity of 7 gallons (31
liters) per minute or 2" (5 cm) in home installation (fig.3- 4).
Floor Standpipe drain:
Top of standpipe must be at least 25 inches (62 cm) high and
no higher than 34 inches (86 cm) from the bottom of
washer (A) (fig. 3-4).
Wall standpipe drain:
25 inches (62 cm) min.; 34 inches (86 cm.) max
from end of drain hose to bottom of washer (B) (fig. 5).
www.aristonappliances.us
PLUMBING
= Hot
PLUMBING
(Water Inlet)
Connection to the water mains
Water pressure must range within the values indicated on the
data plate on the rear of your washer-dryer. If the water pipes are
new or left unused, then before connecting the machine run the
(Water Out)
25”
2
Fig. 2 - Drainage
Fig. 4 - Drainage
water until clear to remove
debris. Connect the inlet hose
to a cold water tap having a ¾"
BSP thread. Ensure that there
are rubber washers are at each
end of the inlet hose. The L-
Shaped end goes on the
machine and straight ends on
the water faucets
Fig. 1 - Water pipe inlet at the
rear top right
25"
34"
Fig. 3 - Drainage
Fig. 5 - Drainage
Instructions for installation and use
7
Publicité
Table des Matières
