Zibro ARABELLA Manuel D'installation page 43

Masquer les pouces Voir aussi pour ARABELLA:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
The surface of the stove can become very hot when in use. Use appropriate
-heat proof- personal protection such as gloves when operating the stove.
Take care with in�ammable clothes, as clothes might catch fire when in close
range with the fire inside the stove.
Do not work with in�ammable solvents in the same room as where the stove
is working. avoid risk, remove inflammable solvents and combustible materi-
als from the room.
The stove is heavy, have the strength of the �oor checked by an authorized
expert.
Have the chimney cleaned and swept regularly following the local legislation
and or your insurance prescription. if no local legislation and/or insurance
prescription: make sure that at least twice per year (first time at the begin-
ning of the heating season), your entire stove system -including chimney- is
checked and maintained by an authorized specialist. When intensively using
the stove the whole system including the chimney must be cleaned more fre-
quently.
Only connect one woodstove per chimney �ue.
Always be in compliance with the instructions of the local fire department.
this stove also requires an electrical power input. please carefully read the below
warnings and remarks:
Do not use a damaged power cable.
Do not clamp or bend the cable.
Make sure the power cable does not touch any hot parts of the stove
Do not use an extension cord.
Check the mains voltage. This device is suitable exclusively for earthed soc-
kets – connection voltage 230 Volt/ 50 hz.
The device MUST always have an earthed connection. You may absolutely
not connect the device if the power supply is not earthed.
The plug must always be easily accessible when the device is connected.
Before connecting the device, check that:
The connection voltage corresponds to that on the type plate.
The socket and power supply are suitable for the device.
The plug on the cable fits the socket.
Have the electrical installation checked by a recognised expert if you are not
sure that everything is in order.
Never cover the air inlets and outlets.
Do not insert ob�ects into the openings of the device.
Never allow the device to come into contact with water. Do not spray the
device with water or submerge it as this may cause a short circuit.
Always take the plug out of the socket before cleaning or replacing the de-
vice or a part of the device.
Always take the plug out of the socket before operating any maintenance to
the stove.
NEVER connect the device with the aid of an extension cable. If a suitable,
4
43

Publicité

Table des Matières
loading

Table des Matières