Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
WARNING!
If the water heater has been damaged or exposed to fire or
sooting, or if any part has been underwater, do not use.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which as been underwater and to clean
the heater exchanger assembly and water valve.
FILLING
Before proceeding with operation of the water heater make
sure that the system is filled with water:
-
Make sure drain is closed. See figure 8, below.
-
Open a nearby hot water faucet to permit the water to
fill the heater and piping.
-
Close the hot water faucet after the water flows freely
and all air has escaped from the system.
The water heater is now ready to be lit.
Figure 8
SERVICE HINT
The screen (strainer) in the water valve, located in the inlet
of the water valve, may require occasional cleaning due to
foreign material in the water supply. This will restrict the
flow of water and may affect heater operation and prolong
filling time. To inspect the strainer, close the cold water sup-
ply valve ahead of the heater, disconnect the S-bend from
the inlet of the water valve and remove strainer from inlet.
Clean if required, replace strainer in inlet to the water valve,
reconnected S- bend and turn on water supply.
Light the water heater in accordance with the instructions
on the Lighting and Operating Plate on the water heater.
For your convenience, the instructions are repeated here:
BATTERY INSTALLATION
If the LED light is flashing, prepare to
Align batteries as
shown
replace the batteries. Use two D cell (1.5
volt) long life alkaline batteries.
LIGHTING AND OPERATING INSTRUCTIONS
1. STOP! Read the safety information above on this label.
2. The gas valve must be shut off by putting the ON/OFF
switch to position "0". Wait five (5) minutes to clear out
any gas. If you smell gas, STOP! Follow "B" in the safety
information above. If you do not smell gas, go to the
next step.
3. This water heater is equipped with a safety pilot burner
and an automatic ignition control system.
4. Set the ON/OFF switch (flip down cover plate on frontal
panel strip) market 1/0 to the 1 position. In this position,
the water heater is ready to use.( See Figure 10.)
5. If the red LED indicator light (visible through the
peephole in the front panel strip) is flashing, this is a
warning that the batteries are less than 1.2 volts and
will need to be replaced within the next couple of weeks.
Plan to have two D type 1.5 volt long-life (Alkaline)
batteries available for replacement.
6. Turn the hot water faucet on the minimum flow rate
required to activate the heater. The automatic ignition
system first ignites the safety pilot burner which then
ignites the main burner in about 4 seconds.
7. The pilot flame will extiguish 10-30 seconds after the
burners come on. The burners will remain on until the
hot water tap is turned off.
NOTE: On a first time the initial installation, existence of air
in the gas supply line and in the water line may cause some
ignition delay. In that case, repeatedly open and close the
hot water tap in order to restart the ignition process until all
the air has been purged.
TO TURN OFF GAS TO APPLIANCE
Turn off the manual lever on the gas supply line to the heater
and set the ON/OFF switch to the OFF (0) position.
To operate the heater, set the ON/OFF switch to
position 1. The switch is located behind the flip down
cover plate on the front panel strip.
To shut down the gas on the heater, set the ON/OFF
switch to position 0.
Batteries
Figure 10
Figure 9
Led
7
Publicité
Table des Matières
