Defort DEP-600N Mode D'emploi page 2

English
• If any chip should get jammed in the chip outlet, you
should switch off the motor, ensure that all moving parts
have come to a complete standstill, disconnect the
Planer plug, and remove the jammed chip
• Before using the tool check that the knives do not
brush anywhere
INTENDED USE • Keep your fi ngers away from the rotating knives
This tool is intended for planing wooden materials such • Always disconnect plug from power source before
making any adjustment or changing any accessory
as beams and boards; it is also suitable for chamfering
edges and rebating WHEN CONNECTING NEW 3-PIN PLUG (U.K. ON-
LY):
TECHNICAL SPECIFICATIONS 1 • Do not connect the blue (= neutral) or brown (= live)
wire in the cord of this tool to the earth terminal of the
PRODUCT ELEMENTS 2 plug
• If for any reason the old plug is cut off the cord of
this tool, it must be disposed of safely and not left unat-
1. Safety switch
2. On/off switch tended
3. Knob for setting planing depth
Your machine is double insulated in accord-
4. Planing depth indicator
5. Dust port ance with EN 50144; therefore no earthwire is
required.
SAFETY
MAINTENANCE
WARNING! Read all instructions. Failure to follow all in-
structions listed below may result in electric shock, fi re
and/or serious injury. Make sure that the machine is not live when
carrying out maintenance work on the motor.
• Avoid damage that can be caused by screws, nails
and other elements in your workpiece; remove them Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots free
before you start working
from dust and dirt.If the dirt does not come off use a soft
• Always keep the cord away from moving parts of the
tool; direct the cord to the rear away from the tool cloth moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water, etc. These sol-
• Wait for the cutter block to stop before setting
vents may damage the plastic parts.
the tool down (an exposed knife may engage the
surface leading to possible loss of control and seri- The machine requires no additional lubrication.
ous injury) Should a fault occur, e.g. after wear of a part, please
contact your local SBM Group dealer.
• Use completely unrolled and safe extension cords
with a capacity of 16 Amps (UK 13 Amps)
ENVIRONMENT
• In case of electrical or mechanical malfunction, im-
In order to prevent the machine from damage during
mediately switch off the tool and disconnect the plug
transport, it is delivered in a sturdy packaging. Most of
• SBM Group can assure fl awless functioning of the
tool only when original accessories are used the packaging materials can be recycled. Take these
materials to the appropriate recycling locations. Take
• This tool should not be used by people under the
your unwanted machines to your local SBM Group
age of 16 years
• The noise level when working can exceed 85 dB(A); dealer. Here they will be disposed of in an environmen-
wear ear protection tally safe way.
• Wear a dust protection mask when working with ma-
terials which produce dust that is detrimental to health;
inform yourself beforehand about the materials to be
worked on
• If the cord is damaged or cut through while working,
do not touch the cord, but immediately disconnect the
plug
• Never use tool when cord is damaged; have it re-
placed by a qualifi ed person
• Always check that the supply voltage is the same as
the voltage indicated on the nameplate of the tool (tools
with a rating of 230V or 240V can also be connected to
a 220V supply)
6