Technical Data; Installation - Zanussi ZRT623W Notice D'utilisation

Technical data

Dimension
Rising Time
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there are two spacers
which must be fitted as shown in the figure.
20
Height
Width
Depth
Ambient temperature
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
1404 mm
545 mm
604 mm
19 h
1. Fit the spacers into
the holes. Make sure
that the arrow (A) is
positioned as shown
in the picture.
2. Turn counter-clock-
wise the spacers
through 45° until they
lock into place.
Levelling
When placing the appli-
ance ensure that it stands
level. This can be achieved
by two adjustable feet at
the bottom in front.
A
45˚