Power Options; Charging The Handheld Eid Reader - Gallagher HR5 Notice D'installation

3E3183 Gallagher HR5 Hand Held EID Tag Reader User Manual

POWER OPTIONS

When the HR5 is fully charged, it is expected to operate for 3–4
working days in typical yard applications.
Charge time will vary depending on the capacity of the power
adapter. Fastest charging is achieved via the mains adapter when
the reader is off (approximately 8 hours).
Important: It is recommended the Gallagher 5 VDC USB charger,
supplied with your HR5 reader, is used when charging off mains
power. Always charge the battery indoors.
Note: Tags cannot be read while the Reader is connected to mains
power. The Reader will operate while being charged using the car
charger, battery or PC, however charging will take longer while the
Reader is in use with the backlight on.

Charging the Handheld EID Reader

The internal battery of the Reader can be charged using :
• a 5 VDC USB mains power adapter
• the 12 - 24VDC USB car charger included with the Reader
• a 12 V vehicle battery.
Connect the components needed (supplied with your HR5) for
your preferred charging method as shown below and plug into the
necessary power source for your charger.
USB Cable connector
USB Cable
5 VDC USB charger
USB car charger (12 - 24 VDC)
12 V battery cable
Standard 12 volt battery
Black Red
23