Recipe Book; Pre-Cooling - Diamond CF1N/F86 Manuel D'installation, D'utilisation Et D'entretien

ENGLISH
5.5.

Recipe Book

GB
Selecting the area
the recipe book is loaded.
From this area you can enter the MY RECIPES
screen, which lists the automatic proving cycles
saved and named by the user. There are up to
100 positions for storing recipes.
By pressing the desired recipe name, you can
directly access the automatic cycle start page
(see specific chapter).
5.6.

Pre-cooling

By selecting the area
menu, it is possible to activate the pre-cooling of
the cell in preparation for the selection of a
proving cycle. Following screen will be proposed:
It is possible to set the cell temperature setpoint;
to start the function, press the key
When the function is active, the corresponding
area will turn blue and the temperature measured
in the cell will be displayed.
from the main menu
from the main
.
12
Just touch the screen to exit the "SCREEN
SAVER" mode.
The manual interruption can be performed in any
phase by keeping the
least 4 seconds.

Phase 5 (delayed cooking) is optional and
has no duration settings, it can only be terminated
manually by pressing the

The choice of a recipe with dashes is not
allowed, the pressure on the corresponding area
will have no effect.
When the setpoint is reached the first time, the
controller will beep. If the temperature in the cell is
equal to or lower than the setpoint set, the pre-
cooling function can not be activated.
The pre-cooling function has infinite duration, it
ends only when a cycle is started, either manual
or automatic, or when it is interrupted by pressing
the key .
key pressed for at
key.