Turning The Projector Power On - Yamaha DPX-1300 Mode D'emploi

Turning the projector power on

Turning the power on
Always remove the lens cap before operating the main unit.
STANDBY/ON
STANDBY/ON
indicator
ESCAPE MENU
PATTERN SETTING
ASPECT INPUT
LAMP COVER TEMP FAN
OUT IN
DVI HDMI REMOTE RS-232C
INPUT B INPUT A
RGB/YP B P R /YC B C R D4 VIDEO G/Y B/P B /C B R/P /C R R HD/SYNC VD S-VIDEO
AC inlet
button STANDBY/ON button
AUTO
V. POS ZOOM FOCUS
IRIS SETTING PATT
ESCAPE
MENU
ESCAPE
PATTERN
ASPECT
LAMP
INPUT
ASPECT
Remote Control Main unit
18
1. Insert the supplied power cable
firmly into the AC inlet at the rear
of the main unit, then insert the
plug into an AC outlet.
The STANDBY/ON indicator lights red.
TRIGGER OUT
VIDEO
2. Press the STANDBY/ON button
(the
control).
STANDBY/ON
The indicator blinks green and the lamp
lights up in preparation for projection. After
approximately 35 seconds, the indicator
MENU
changes from blinking to steady green,
SETTING
indicating that the unit is ready to project.
INPUT
COVER TEMP FAN
Warning
• Do not remove the power cable while the STANDBY/ON indicator is blinking green or
lit steady green. This could damage the lamp or reduce lamp life.
button on the remote