Emerson C1300 Manuel Du Propriétaire page 7

TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
Water and steam spits • Unit is boiling.
forcefully from spout
May be normal during initial setup.
without turning on the
dispenser faucet.
Water is not hot. • The unit may not be plugged in.
• The electric outlet is inoperative.
Water is too hot • Thermostat is not adjusted to
or not hot enough. your needs.
Water comes out the • Outlet tube is blocked.
vent instead of spout.
Water is dripping from • The expansion chamber isn't
the spout/vent draining properly due to low
intermittently. water pressure.
• The spout is blocked.
Water is dripping • Debris in the water line may be
from the spout/vent in the faucet valve seat causing a
constantly. slow water leak.
Water discoloration/ • Corrosion of unit.
rusty appearance.
If you are still experiencing trouble, visit
www.insinkerator.com/foodservice or call 1-800-845-8345.
An instant hot water dispenser, like any water heater, has a limited life and will eventually fail. To avoid
possible property damage, this instant hot water dispenser should be regularly examined for leakage and
replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector,
should be used in those applications where any leakage could cause property damage.
12
WHAT TO DO
• Activate faucet lever to release some water from
the tank.
• Adjust water temperature using dial on tank front.
Remember that at higher altitudes, water boils
at lower temperatures.
• Make sure the unit is connected to a properly grounded
electric outlet.
• Make sure the circuit breaker or fuses are
functioning properly.
• Check that the outlet is not switched off.
• Adjust the thermostat slowly, then activate faucet handle
for 20 seconds to bring in fresh water to be heated at
the new setting. Allow 5-7 minutes for water to reach
new temperature.
• Check that outlet tube is not kinked, twisted or pinched.
• Unscrew spout end piece and clean out any debris.
• Unplug the unit. If the dripping doesn't stop after a few
minutes, check the supply valve to ensure that is fully
open and there are no obstructions in the water line
reducing the pressure below 30 psi (i.e., a poorly
mounted saddle valve, a clogged water filter, or a
partially opened shut-off valve).
• Unscrew spout end piece and clean out any debris.
• Unscrew spout end piece and clean out any debris.
• Activate faucet lever 7-10 times to flush faucet & lines.
• Unplug and drain unit as described in the Seasonal
Storage/ Drainage Section on page 8 of this manual.
If the water discoloration remains after draining and
refilling unit, discontinue use and contact an
authorized InSinkErator service agent.
Dispensador de agua caliente instantánea
Manual del usuario
Instalación, cuidado y uso
Installation, Care & Use
Installation, soin et utilisation
C1300