ASROCK 939SLI32-eSATA2 Mode D'emploi page 25

2.9 2.9 2.9 Serial A Serial A Serial AT T T T T A (SA A (SA A (SAT T T T T A) / Serial A A (SA
2.9 2.9 Serial A Serial A A (SA
Installation Installation Installation Installation Installation
This motherboard adopts ULi M1697 southbridge chipset that supports Serial ATA
(SATA) / Serial ATAII (SATAII) hard disks and RAID (RAID 0, RAID 1, RAID 0+1,
JBOD, and RAID 5) functions. You may install SATA / SATAII hard disks on this
motherboard for internal storage devices. This section will guide you to install the
SATA / SATAII hard disks.
STEP 1: Install the SATA / SATAII hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA / SATAII hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATAII
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA / SATAII hard
disk.
1. If you plan to use RAID 0, RAID 1, or JBOD functions, you
need to install at least 2 SATA / SATAII hard disks. If you plan to use
RAID 5 function, you need to install at least 3 SATA / SATAII hard disks.
If you plan to use RAID 0+1 function, you need to install at least 4 SATA
/ SATAII hard disks. If you install 2 eSATAII devices, then only RAID 0,
RAID 1, or JBOD functions will be enabled.
2. If you plan to use RAID functions on SATA / SATAII, SATA / SATAII HDDs
must be operated in "RAID" mode.
3. "RAID" and "non-RAID" mode are options under "SATA Operation Mode" in
BIOS setup. Please refer to page 41 of "User Manual" in the Support CD
for details.
ASRock 939SLI32-eSATA2 Motherboard
A) / Serial AT T T T T AII (SA A) / Serial A A) / Serial A AII (SAT T T T T AII) Hard Disks AII (SA AII (SA
A) / Serial A AII (SA
AII) Hard Disks AII) Hard Disks AII) Hard Disks
AII) Hard Disks
2 5 2 5 2 5
2 5 2 5