RU Инструкция по применению
5. Mount the cooker hood on the screws (A, B),
align it horizontally and tighten the screws
with the screwdriver. When the alignment is
finished the cooker hood must be fixed with
the screws in holes (C, D) from the inside
(pic. 11).
If the cooker hood will be operating in the air
extraction mode put one end of the flexible
duct (not included in the set) onto the adapter
flange. Apply the sealing paste on the joint
area and hold it by the clamp (not included in
the set) (pic.15). The other end of the flexible
duct should be connected to the ventilation
outlet.
You should avoid the needless bends of the
duct. The shorter and straighter is the duct
(without needless bends), the more effective
and less noisy and vibrating the cooker hood
is.
6. If the cooker hood will be operating in the re-
circulation mode, the carbon filters should be
installed (not included in the set) (pic. 9). In
this operating mode the duct installation is not
necessary (pic. 13).
7.
Before adjusting the decorative chimneys you
should bring out the cord for connecting the
cooker hood to the mains.
8. Place the internal decorative chimney into the
external decorative chimney (for BELLA 3P
model). Place the external chimney onto the
cooker hood body and fix it with screws. Lift
the internal chimney so that to bring together
the attachment points of the chimney and the
panel and fix them with the screws (pic. 13).
ВЫТЯЖКИ КУХОННЫЕ
The kitchen hood is connected to the power net-
work with the voltage of 220–240V, 50 Hz.
The kitchen hood should be connected to a wall
outlet with earthing to avoid electrocution.
It is absolutely prohibited to cut off the plug
during kitchen hood installation.
The damaged electrical cord should be re-
placed by a qualified service specialist.
For additional protection of the kitchen hood from
voltage drops in the network, connect it though an
additional automatic switch 6A.
CONNECTION TO POWER SUPPLY
The kitchen hood is installed.
Switch it on and use it as you please.
11