Overhauls; Service; Servicing Report; Installation - Ferrari 2 FPF Manuel D'utilisation

GB PALLETT FORKS

9.2 Overhauls

Must be carried out by specialised
personnel with suitable tools.
Possibility of residual pressure in the circuit: before
any operation, discharge the pressure of the machine
and disconnect the equipment.
The extraction of the pins may cause unpredictable
movements in the structural work: immobilise the parts
before performing any operation.
Use only original spare parts.
For spare parts orders, please specify:
- MODEL
- SERIAL NO.
- YEAR OF MANUFACTURE
To be performed every 500 working hours:
- verify that the play between pin and bush is less than
0.6 mm; if greater, replace the worn parts;
- check the seal of the cylinder gaskets and replace if
necessary;
- check the condition of the hoses and replace if
necessary;
- check the condition of the metal structure, if
necessary replace the damaged parts;
- check the tightness and condition of the pin locking
nuts and the bolts joints;
- check that the equipment is working properly.

9.3 Service

For any repairs or overhauls, contact Ferrari Int2 so we
can provide qualified personnel and suitable tools.
We also offer technical service at our headquarters for
any information, advice, and indications on authorised
service centres.

9.4 Servicing report

9.4.1 Installation

DATE REPORT NO. SUPERVISING TECHNICIAN
SIGNATURE

10. SPARE PARTS

To identify a spart part, follow the procedure described
below:
• Locate the part and its position number on the
specific drawing of the assembly.
• Consult the table and, in correspondence with
the position, find the information necessary for
ordering the part:
1. Code
2. Description of the part
3. Quantities fitted on the machine (Qty)
• Complete the order form and Ferrari International
2 will supply the spare parts.
We recommend that you record in the manual the
periodic servicing operations and/or special
maintenance operations carried out so that, when
necessary, it will be faster and easier to find the
problems and therefore the most economical solution.
The equipment purchased must always be kept in
perfect working order. Therefore, when spare parts are
required it is indispensable to use only original spare
parts, requesting them directly from the manufacturer
or through your authorised dealer.
Applying spare parts of inferior quality may cause
damage to other components.
The positive outcome of the maintenance and overhaul
operations depends on the instructions and advice
suggested based on our experience.
T E C H N O L O G Y M A D E I N I T A L Y
25