Aligning The Appliance - Thermador T18BF Série Instructions D'installation

11. Aligning the appliance

m
CAUTION
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– If using a wooden beam as an alternative anti-tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.
Remove base panel from the appliance.
Align the appliance with the furniture fronts.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front: with open-ended wrench
5
Rear: with / " (8 mm) hex nut driver via flexible shaft.
16
24
m
1
/ " (SW13)
2
A mark is attached to the appliance base and is used as a
standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
floor.
Unscrew the height-adjustable feet until the mark on
the base has reached the indicated guide dimension
1
(1 / " / 32 mm).
4
It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
Align the furniture fronts with the spirit level.
Before attaching the appliance in the cavity, check
– that the top and sides of the frame are situated on
the cavity front,
– that the finger guard functions by opening and
closing the door several times.
1
/ " (32 mm) above the
4
NOTE