Güde MD 1700 Traduction Du Mode D'emploi D'origine page 13

In the course of work, the blades will heat up to a high
•
temperature; do not touch them before they cool down.
Always use a dust-exhausting device.
•
See also General Safety Instructions and Initial Operation
Safety Instructions.
Step-by-Step Instructions
Mark the required course of joint with a twisted cord.
•
Connect the cutter to the dust exhaust.
•
Wear/Use the safety aid needed – breathing mask,
•
goggles, hear protectors.
Plunge the diamond disc in the masonry at the highest
•
place of the cut and make a slow protracted cut.
Clean the unit thoroughly after the use.
•
Troubles – Causes – Troubleshooting
Will not cut:
1. Disc is blunt
Sharpen or replace the disc.
Will not run:
2. Defective cable
Replace or repair the cable
Great quantities of dust forming:
1. Dust exhaust bag full.
Replace the dust exhaust bag.
Inspection and Maintenance
Pull over all work on the equipment the power cord.
The machine will serve as a sufficient aid only if
•
maintained and care for appropriately. Insufficient
maintenance and care may result in accidents and
injuries.
Clean the unit thoroughly and check on the diamond
•
discs integrity.
13-GB