Prior To Operation; Assembly And Operation - Einhell Global OF-G 1100E Mode D'emploi

Anleitung OF-G 1100 E 12spr.
GB

5. Prior to operation

Before starting the router, make sure that all its
guards and safety devices are properly fitted.
Before connecting up the router, make sure that
your power supply complies with the data on the
machine's rating plate.

6. Assembly and operation

Important!
Pull out the power plug before fitting any parts or
making any adjustments.
A.) The extractor socket (Item 14 / Fig. 1)
Important! For the sake of your health, always
use a dust extractor.
Connect a suitable dust extractor to the extraction
socket (14).
B.) Fitting the parallel stop (Fig. 2)
Insert the guide shafts (17) of the parallel stop
(18) in the holes (13) of the routing base (7).
Adjust the parallel stop (18) to the required
distance and clamp it in place with the thumb
screws (9).
The parallel stop can be set to the exact
dimension by turning the fine adjustment device
(19).
C.) Fitting the trammel point (Fig. 2/3)
Undo the thumb screws (a) on the parallel stop
(18) and pull out one guide shaft (17).
Slide the trammel point (21) onto the guide shaft
(17) of the parallel stop (18) and fasten with the
thumb screw (b).
Place the trammel point against the material.
Set the required radius by adjusting the parallel
stop (18) and fixing it in place with the thumb
screw (9).
Switch on the machine.
Release the clamping handle (12) and lower the
machine slowly as far as the stop (see Section
F).
Cut grooves, shoulders, etc. at a steady rate of
feed, holding the machine with both hands.
When finished, raise the machine again.
Switch off the machine.
D.) Fitting the guide bush
Use the two countersunk head screws to fasten
the guide bush (22) to the routing base.
8
24.10.2001 10:50 Uhr
The template (c) is traced with the guide ring (b)
of the guide bush (22).
To obtain an exact copy, the workpiece (d) must
be bigger by an amount equal to the difference
between the 'outer edge of the guide ring' and
the 'outer edge of the cutter' (e).
D
22
d
E.) Fitting the cutter
Important: Pull out the power plug!
Press the spindle lock (10) and unscrew the
clamping nut (15) from the spindle (16).
Insert a collet in the spindle (8) to match the
cutter you want to use.
Loosely screw the clamping nut (15) on the
spindle.
Insert the cutter in the collet.
Press the spindle lock (10) and use the open-
ended spanner (20) to tighten the clamping nut
(8).
Important: Make sure that all adjustment and
assembly tools are removed before starting the
machine.
Dismantle the cutter in reverse order.
F.) Adjusting the depth of cut
Place the machine on the workpiece.
Undo the thumb screw (5) and release the
clamping handle (12).
Lower the machine slowly until the cutter touches
the workpiece.
Secure the clamping handle (12).
Set the depth stop (4) to the required routing
depth using the scale (3) and the turret stop (6).
You can choose from three depth stop settings
by turning the turret stop (6).
Use the thumb screw (5) to fix the depth stop (4)
in position.
Press the ON/OFF switch (1) to switch on the
machine.
Use the speed selector (2) to set the required
cutter speed.
Seite 8
c
b
e