Safety Instructions; Operating The Appliance; Switching On; Power Mode - CASO DESIGN W2100 Mode D'emploi

Attention
► The maximum permissible weight of the pot plus its contents must not exceed 6 kg.
► Be careful when using hollow-walled simmer pots. Pots of this type can boil dry
unnoticed. This leads to damage to the pot and hob.

14.3 Safety Instructions

Warning
► Do not leave the appliance unattended during operation, so that you can intervene
quickly in the event of danger.
► Do not move the appliance during operation or with hot cookware on the hot plate.
► Ensure that the cookware is properly centred on the hob. It must not be positioned on
the control panel or on the frame.
► In order to prevent overheating do not place any aluminium foil or metal panels on the
appliance surface.
► Do not touch the hot surface of the ceramic hob.
Although the induction cooktop itself does not produce any heat during the cooking
process, the temperature of the cookware does heat up the hob.
► Keep the hob and the underside of the pot clean and dry at all times. If liquid gets
between the base of the pot and the hob, this liquid can vaporise and the resulting
pressure can cause the pot to jump into the air, with a resulting risk of injury.
► Switch the appliance off after use. This avoids unnecessary use of energy, and ensures
your safety.
► If the appliance is unused for extended periods of time, we recommend that the
appliance be unplugged from the mains.

14.4 Operating the Appliance

14.4.1

Switching On

Plug the power plug into a suitable outlet. The temperature of the cooker plate surface
displayed: is the temperature of the surface of the induction cooker lower than 50°C, the
display shows „L". When the temperature of the cooker plate surface is over 50 °C, it is
displaying „H". An acoustic signal sounds. Now the device is in standby mode.
Place a suitable cooking pot with its contents to be cooked on the centre on the hob (Ø
140 mm - 240 mm). Now press the ON/STANDBY switch 1. to turn on the device. The
control lamps "Level" and "Temp" blink and an acoustic signal sounds.
14.4.2

Power Mode

Press the function key 4. The preset power stage "8" is selected and the device turns on.
With the + / - Keys (5+6).
You can change the settings at any time in a range from 1 – 12.
caso W2100 / S-LINE 2100 / PRO MENU 2100 / Maitre 2400 41