Adjusting the splitting cross:
1.
Loosen hexagon
screw.
2. Move the splitting
cross to the
correct position.
(The hexagon
screw lies above
the hole in the
splitting blade).
3.
Tighten the
hexagon screw
again.
Splitting short wood:
1. Upper position of table plate.
2. Place the log on the splitter's table plate.
3. Hold the log tight with the clamping claws.
Only split the logs in the direction of the wood fibres.
Splitting long wood:
1. Middle position
of table or low
position of base.
2. Remove the
splitting cross.
3. Place the log on
the splitter's
table or base.
Possible malfunction when cleaving logs: The log to be
cleaved is not cleaved right through, jams on the cleaving blade
and is pulled up during the blade's return movement.
In this case, proceed as follows:
1. Switch off the device.
2. Depending on the log still to be cleaved fix the table plate in
the upper or the table in the middle position.
3. Switch on the device and continue the splitting operation.
Never try to split two logs at once.
Never try to remove or replace the log during the
splitting process.
Never try to force the splitting of the log by maintaining the
pressure for several seconds. This can lead to damage to the
machine.
Position the log on the table again and repeat the splitting phase,
or put the log on one side.
28
Hexagon screw
Splitting cross
How to release a jammed log?
There is a risk of knotted logs getting stuck during the splitting
process.
1. Switch machine off and disconnect the power.
2.
Do not remove jammed logs with your hands.
3. Carefully move the stuck log with a crowbar backwards and
forwards to loosen it. Don´t damage the splitting pillar.
Never hammer on the stuck log.
Never use a saw to cut the stuck log out of the machine.
Do not enlist the aid of a second person - this is a one-
man job.
Finishing work:
Bring the splitting blade to the lower position (run-in state).
Release one of the control handles.
Switch the machine off and disconnect the power.
Follow the care and maintenance instructions.
M
a
i
n
t
e
n
a
n
c
e
a
n
d
M
a
i
n
t
e
n
a
n
c
e
a
n
d
Before each maintenance and cleaning work:
− switch off device
− pull out main plug
Wear protective gloves in order to avoid injury to the
hands.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Be sure to have removed any tools from the machine after
completion of service work.
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
To guarantee a long and reliable usage of the product carry out
the following maintainance works regularly.
Observe the following in order to keep the log splitter in
good working order:
Clean the machine thoroughly after you have finished
using it.
Loose fastening elements.
Worn out or damaged parts.
Remove any resin remains on the machine.
Lubricate the splitting column regularly or oil it using
environmentally friendly spray oil.
Check hydraulic hoses and hose connections regularly
for any leaks and firm fitting.
Correct assembly and faultless covers and protective
devices.
c
l
e
a
n
i
n
g
c
l
e
a
n
i
n
g