Product Description - claber Rotoroll EVOLUTION 20 Mode D'emploi

Use

PRODUCT DESCRIPTION

1) Tap connector Ø 3/4"
2) Plugs, pins, screws and washers for
fixing the reel to the wall
3) Stopper/damper
4) AQUASTOP coupling Ø 1/2"
5) Spray nozzle
6) Wall support
7) Extension hose
8) Coupling Ø 1/2"
INSTALLATION
WARNING Make sure that the wall
is solid and stable.
1) Cut out the template from the box, rest
it against the wall and level it.
Mark the holes on the wall and drill
them using a Ø 12 bit.
2) Insert the plugs. Insert two pins in the
two bottom plugs.
3) Slot the reel support onto the two pins
and fix in place using the three screws
and three washers, using a 10 mm box
spanner.
4) Mount Rotoroll onto the wall support
by threading the metal pin on the reel
into the hole in the support.
If the product is located in a place open
to the public, you may fit a padlock (not
included in the package) under the
wall support, by threading it through
the hole in the metal pin.
5) Using a screwdriver, loosen both of the
screws on the hose stopper.
Move the hose stopper into the desired
position.
Fix it in place by retightening the
screws.
8696_8697_Rotoroll_evolution.indb 9
HOW TO USE THE PRODUCT
WARNING When unreeling and
rewinding the hose, do not put
your fingers in the hose feed slot
(Fig. A). Make sure that the hose is
not obstructed by obstacles, dirt
or similar as it rewinds.
The first time you use the reel (Fig. B),
connect the hose to a tap, then attach the
adjustable nozzle to the end of the hose
and, finally, turn on the tap.
How to unwind the hose
Pull out the hose to the desired length
(Fig. C). The hose automatically clicks into
place.
How to rewind the hose
Pull the hose gently just once to activate
the rewind mechanism. The hose rewinds
back up evenly (Fig. D).
After use
Turn off the tap and open the adjustable
nozzle to release the water pressure.
UK - 2 9
19/12/17 14:28