Hatco GLO-RAY GRSDH Séries Manuel D'installation Et D'utilisation page 18

OPTIONS AND ACCESSORIES
102 mm (4") Adjustable Legs
NOTICE
Do not lay unit on the side with the control panel or damage
to unit could occur.
Carefully lay unit on its side. Install legs to bottom of unit. Hand-
tighten legs until snug. Do not over-tighten. Return unit to the
upright position.
Leg Adjustment
Shorten
Lengthen
Leg Installation
NOTE: Legs are adjustable for leveling the unit. Use a 16 mm
(5/8") open-end wrench to make leveling adjustments
once the unit is placed in final position.
Stainless Steel End Panels
Stainless steel end panels are factory installed options in place
of the glass end panels.
Halogen Display Lights
Optional halogen display light bulbs can be ordered in place of
the standard incandescent display light bulbs.
Flip-Up Door Locking Plates
Flip-up door locking plates are factory installed and are available
as options for GRSDS-XX and GRSDS-XXD models. Flip-up
door locking plates allow access to the server side only.
Flip-Up Doors
Flip-up doors are available as accessories for all models.
The doors can be installed to each shelf on either the customer
side or operator side of the unit. Use the following procedure to
install flip-up doors (the procedure is the same for either side
as well as each shelf).
1. Remove the two screws from the element end cover above
the desired shelf on each side of the unit.
2. align the holes on the mounting brackets with the screw
holes on the element end covers of the unit.
3. Insert the screws removed in step 1 through the mounting
brackets and into the unit. Tighten securely.
4. Place a spacer on each hinge screw (both included with
door).
5. align the screw holes at each end of the channel on the
flip-up door with the hole on each mounting bracket.
6. Insert a hinge screw with spacer through each mounting
bracket and into the flip-up door.
7. Tighten the hinge screws until the flip-up door is secure.
Make sure the spacers on the hinge screws go through the
holes in the mounting brackets. Do not over-tighten the
screws.
End
Cover
Mounting
Bracket
End
Cover
Screw
End Cover
Screw
Flip-Up Door Installation
18
Mounting Mounting
Bracket Bracket
Flip-Up
Spacer
Door
Hinge
Screw
Form No. GRSDCEM1-0514