Craftmade WB242 Mode D'emploi page 5

7
Line up arrow on mounting plate (1) to arrow on fan body inner housing
plate (2). Push outer housing (2) up and twist clockwise approximately
1/2". Outer housing unit will set in mounting bracket. Secure with outer
housing screws (S2).
Line up arrows on mounting
plate and inner housing plate.
Step 7
Outer Housing
Screws (S2)
Outer Housing (2)
8
For blade assembly, position blade arms and blade (4) so that all screw
holes are aligned (as shown in figure below). Using blade screws (S4),
insert through blade and up into blade arms. Tighten securely.
9
Install glass (3) to fan by raising glass to fan and turning glass clockwise
until firmly seated.
Step 8
Blade (#4)
Blade Screws (S4)
Step 9
Glass (3)