Connecting The Water; Switching On The Appliance; Switching Off And Disconnecting The Appliance; Switching Off The Appliance - Thermador T36BT Série Guide D'utilisation

Connecting the
water
A cold water connection is required
for operation of the automatic ice
maker. The water pressure must be
between 25 and 120 p.s.i.
(1.72–8.25 bar).
The installation must comply with
local plumbing regulations and local
and state laws.
A separate shut-off valve must be
installed for the appliance water
connection.
The shut-off valve for the water
connection must not be behind the
appliance. It is recommended to
place the shut-off valve directly next
to the appliance (base unit) or in
another easily accessible location.
Switching on
the appliance
Press the POWER button.
When the appliance has been
switched on, the appliance begins to
cool down. When the doors are
open, the interior lights come on.
The preset temperatures (factory
settings) are reached after approx.
2–8 hours. Do not put any food in
the appliance beforehand.
Do not use the first ice cubes
from the ice maker! Discard the
ice production of the first
24 hours after switching on the
icemaker.
To change the preset temperatures
see "Setting the temperature".
Switching off
and
disconnecting
the appliance
Switching off the
appliance
Press the POWER button.
If switching off the appliance for
a period longer than 2 weeks,
remove the water filter. Before

switching on the appliance

again, install a new filter (see
"Exchanging the filter").
Disconnecting the
appliance
If you do not use the appliance for
a prolonged period:
Shut off the water supply line.
Shut off the water supply line
several hours before switching
off the appliance.
Remove and discard the water
filter. Secure the filter cap!
Take all food out of the
appliance.
Pull out the mains plug or switch
off the fuse.
Empty the ice cube container.
Clean the appliance interior
(see "Cleaning the appliance").
To prevent odors, leave the
doors open.
9