Construction Features; Overall Dimensions - CHAFFOTEAUX AQUANEXT PLUS 200 Instructions D'utilisation

2.2 Construction features (Refer to fig. 14).
1 Fan
Hot gas valve
2
3 Safety pressure switch
4 Electronic expansion valve
5 Evaporator inlet NTC temperature probe
6 Electronic box
Bottom NTC temperature probe (heating
7
element zone)
Electric heating element
8
9 Impressed current anode
Condensate drain pipe
10
2.3 Overall dimensions (Rifer to fig. 2).
A Inlet cold water ¾" pipe
Outlet hot water ¾" pipe
B
C Condensate drainage connection
D Auxiliary circuit ¾" inlet pipe (SYS version only)
E Auxiliary circuit ¾" outlet pipe (SYS version only)
Sheath for upper probe (S3) (SYS only version)
F
2.4 Schema elettrico (Riferimento fig. 3).
1 Power supply (220-230V 50Hz)
Mainboard (motherboard)
2
3 Interface board (display or HMI)
Connection board
4
5 Hermetic rotary compressor
Operation condenser (15µF 450V)
6
7 Hot gas valve
8 Fan
9 Earth pole
Pressure transducer
10
11 Air/Evaporator/Suction NTC temperature probes
Electric heating element (1500 + 1000 W)
12
Heat pump water heater – GENERAL INFORMATION
65
11 Middle NTC temperature probe
Top NTC temperature probe (hot water)
12
13 Hermetic rotary compressor
14 Lateral connections
15 Pressure transducer
16 Low pressure outlet
17 Air NTC temperature probe
Compressor suction NTC temperature probe
18
19 Evaporator filter
Evaporator
20
G Recirculation ¾" pipe (SYS version only)
Sheath for bottom probe (S2) (SYS version only)
H
13 Impressed current anode
Bottom NTC temperature probe (heating element
14
zone)
15 Middle NTC temperature probe
Top NTC temperature probe (hot water)
16
17 Safety pressure switch
Batteries (4x1,2V AA rechargeble)
18
19 Electronic expansion valve
20 Filter
HC-HP signal (EDF) - cable not supplied with the
21
product
PV/SG signal - cable not supplied with the
22
product
23 AUX signal - cable not supplied with the product