Maintenance Table; Troubleshooting - Alpina CS 40 Li Manuel D'utilisation

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the chain catcher
General cleaning and inspection
Cleaning the chain
Check the machine and bar lubrication holes
Check the chain drive sprocket
Chain maintenance
Bar maintenance
Topping up the chain oil level
* Interventions which must be carried out by your dealer or an authorised service centre

14. TROUBLESHOOTING

PROBLEM
1. The motor shuts down
whilst working
2. With the throttle lock button
and throttle trigger lever on,
the chain does not turn
3. The chain heats and
emits smoke on the
end part of the bar.
4. The motor runs irregularly
and lacks power when revved
First time
-
-
-
-
-
-
-
-
-
-
PROBABLE CAUSE
Battery is not inserted correctly
Machine damaged
Excessive chain tensioning
Bar and chain problems
Machine damaged.
Excessive chain tensioning
Lubricant oil tank empty.
Bar and chain problems
EN - 15
Frequency
And then after
every
Before each use
Before each use
Before each use
After each use
After each use
Before each use
Once a month
-
-
Before each use
SOLUTION
Make sure that the battery is
inserted correctly (par. 7.2.3).
Do not use the machine.
Remove the battery and
contact a Service Centre.
Retension the chain (par. 6.1.3).
Check that the chain runs
freely and the bar guides are
not deformed (par. 8.2, 8,3).
Do not use the machine.
Immediately turn off
the machine, remove
the battery and
Contact an Authorised
Service Centre.
Retension the chain (par. 6.1.3).
Fill the lubricant oil
tank (par. 7.3).
Check that the chain runs
freely and the bar guides
are not deformed.
Paragraph
7.7
6.2
7.5
7.4
7.4.2
7.6
8.1 *
8.2
8.3
7.3