Attachments; Maintenance Battery Charger - ST. SpA F 72FL Manuel D'utilisation

PROBLEM
11. U neven mowing and poor grass
collection
12. U nusual vibrations while
working
13. Uncertain or ineffective braking
14. E rratic forward movement,
poor drive when going uphill or
if the machine has a tendency
to rear up
15. W ith the engine running, the
machine does not move when
the drive pedal is pressed
16. T he machine starts to vibrate
abnormally
If problems persist after having performed the above operations, contact your dealer.
WARNING! Do not take on complicated repair work without the necessary equipment and
technical knowledge. The guarantee is automatically revoked and the manufacturer declines
all responsibility for any poorly effected repairs.

8. ATTACHMENTS

8.1 KITS FOR FRONT WEIGHTS
(Fig. 8.1 nr. 41)
These improve the machine's front stability, par-
ticularly when used on slopes.

8.2 MAINTENANCE BATTERY CHARGER

(Fig. 8.1 nr. 42)
This keeps the battery in good working order
when the machine is in storage, guaranteeing
an optimum level of charge and longer battery
life.
LIKELY CAUSE
– c utting-means assembly is not
parallel to the ground
– i nefficient cutting means;
– f orward speed too high
compared to the height of grass
being cut
– c ollector channel is blocked
– c utting-means assembly is full
of grass
– t he cutting means are
unbalanced or loose
– l oose bolts and screws
– t he brake is not adjusted
correctly
– p roblems with the belt or the
engagement device
– r elease lever in position «B»
– d amaged or loose parts
8.3 MULCHING" KIT (Fig. 8.1 nr. 43)
It chops the grass cuttings finely and leaves
them on the lawn, instead of collecting them in
the grass catcher.
8.4 CLOTH COVER (Fig. 8.1 nr. 44)
Protects the machine from dust when not in use.
17
SOLUTION
– c heck the tyre pressure
(see 5.3.2)
– r einstate the alignment of the
cutting-means assembly in
relation to the ground (see 6.4.1)
– c ontact your Dealer
– r educe the forward speed and/
or raise the cutting-means
assembly (see 5.4.5)
– w ait for the grass to dry
– r emove the grass catcher and
empty the collector channel
(see 5.4.7)
– c lean the cutting means
assembly (see 5.4.10)
– c ontact your Dealer
– c heck and tighten all the engine
and frame bolts
– c ontact your Dealer
– c ontact your Dealer
– move it to position «A» (see 4.33)
– stop the machine and
disconnect the spark plug cable
– inspect for damage
– check for and tighten any loose
parts.
– h ave all checks, repair work and
replacements carried out by a
specialized Centre only