Water Drainage - Black & Decker BPACT12H Serie Manuel D'utilisation

SET UP & USE
WATER DRAINAGE METHOD
This air conditioner is equipped with the very latest MIST technology which
means the water tank nearly never fills, hence water drainage will generally
only be required at the end of the season (see START-END OF SEASON
OPERATIONS in page 19. However the MIST technology does not operate when
the unit is in HEAT mode. Thus the tank may still require emptying in HEAT
mode.
NOTE: As a safety measure to positively prevent water spillage the air
conditioner is equipped with a fail safe device if the water tank fills. The
unit will completely stop, the control panel displays ft (FULL TANK) as
mentioned on SELF DIAGNOSIS in page 17. The compressor and fan will
not restart until the tank has been drained.
INTERMITTENT DRAINAGE (FIG. 10 AND FIG. 11)
• Turn the air conditioner off then drain the water tank by unplugging the drain
cap and allowing the water to flow into a receptacle pan. Your pan may not
hold the full contents of the water tank. A number of fills of your pan may be
required.
• To insure all water has been removed tilt the unit by lifting it slightly upwards
from the front until no more water drains from the outlet.
• Restart the air conditioner by pressing the power button. Ensure that the unit is
in COOL or DRY mode. The compressor will start approximately 3 minutes after
the unit is switched on.
Figure 10
Page 18
Figure 11