Window Slider Kit Installation - Black & Decker BPACT12H Serie Manuel D'utilisation

SET UP & USE

WINDOW SLIDER KIT INSTALLATION

Your window slider kit has been designed to fit most standard "Vertical" and
"Horizontal" window applications; however, it may be necessary for you to
improvise/modify some aspect of the installation procedures for certain types of
window. Minimum and maximum window openings:
MAXIMUM : 59" (145 cm)
NOTE: · A plastic locking pin is holding the window slider kit together during shipment. Prior
to installation, remove plastic locking pin, adjust to desired length and use provided
metal locking screws to secure.
NOTE: · If the window opening is less than 20.5" the minimum length of the window slider
kit, cut the one with a hole in it short to fit for the window opening. Never cut out
the hole in window slider kit.
Horizontal Window
DOUBLE-HUNG SASH/SLIDING CASEMENT WINDOW
INSTALLATION
1. Cut the foam seal (adhesive type)
to the proper length and attach it
to the window sash.
2. Attach the window slider kit to the
window sash. Adjust the length of
the window slider kit according to
the width of window. Shorten the
adjustable window kit if the width
of window is less than 20.5".
3. Cut the foam seal (adhesive type)
to the proper length and attach it
on the top of the window.
4. Close the window securely against
the window slider kit.
5. Secure the window slider kit to the
window sash.
6. Cut the foam seal to an
appropriate length and seal the
open gap between the top window
frame and outer window frame.
Page 10
Vertical Window Window Slider Kit
Foam
Seal
Window Sash
Window
Slider Kit
Window
Slider Kit
Foam
Seal
Cut on opposite
side of hole.
Foam
Seal
20.5"~59"
Window
Slider Kit
Window
Slider Kit
Foam
Seal