Engaging The Parking Break; Lifting The Machine; Transporting The Machine; Towing Or Pushing A Disabled Machine - Nilfisk Advance 56511710 Mode D'emploi

ENGAGING THE PARKING BRAKE
CAUTION!
When parking on an incline, turn the steering wheel fully in one direction such that if the parking brake were to be accidentally
released or fail the machine would not roll and cause damage or bodily injury, if necessary, block the wheels.
A. To Engage Parking Brake:
1. See Figure 2. Press the Brake Pedal (38) completely.
2. With the brake pedal pressed, rotate your foot to engage the Parking Brake Pedal (38A).
B. To Release Parking Brake:
1. See Figure 2. Press the Brake Pedal (38) to disengage the parking brake pedal.
FIGURE 2

LIFTING THE MACHINE

CAUTION!
Never work under a machine without safety stands or blocks to support the machine.
• When lifting the machine, do so at designated locations (Do Not lift on the hopper).
• See the Lift Point / Tie Down Point locations (33) shown on page A-9.
• See Figure 3. Lift Point / Tie Down Point symbols.

TRANSPORTING THE MACHINE

CAUTION!
Before transporting the machine on an open truck or trailer, make sure that:
• All access doors are latched securely.
• The machine is tied down securely. See the Lift Point / Tie Down Point locations (33).
• The machine parking brake is set.

TOWING OR PUSHING A DISABLED MACHINE

CAUTION!
If the machine must be towed or pushed, make sure the Key Switch is in the Off position and do not move the machine faster than a
normal walking pace (2-3 mph, 3-5 kph) and for short distances only.
4/2017
INSTRUCTIONS FOR USE
38
FIGURE 3
Lift Point / Tie Down Point symbol
56091206 - CS7010
ENGLISH - A
38A
A - 7