Directions For Use - Hayward C250EXP Manuel D'installation Et Mode D'emploi

FIGURE I
B. Connection to Chlorinator
1. Remove the polyethylene bag containing the
control valve, check valve and Teflon tape from the
chlorinator carton and remove items from bag.
2. Using the provided Teflon tape wrap th threads of
the check valve and then thread it securely into the
outlet port of the chlorinator. See figure II.
3. Similarly wrap the male threads of the control
valve with Teflon tape and then thread it securely
into the inlet port of the chlorinator. See figure II.
C. Connection to Plumbing
1. Once the chlorinator has been positioned following
the instructions in "A" above and the control and
check valves have been installed according to the
instructions in "B" above piping connections to the
chlorinator may be made using minimum schedule
40 PVC or CPVC pipe.
2. Connect the inlet and outlet ports of the chlorinator
to the minimum schedule 40 pipe using "thread to
slip" pipe adapter fittings not included with unit.
Wrap threaded ends of the adapters with Teflon
tape and use proper primer and adhesive for
non-threaded (slip) connections.
3. After starting system, re-check all plumbing
connections for leaks. Re-tighten threaded
connections or remake slip connections if
necessary.
(#1)
(#7)
(#6)
(#5)
(#4)
C C H H E E M M C C A A L L
F F E E E E D D E E R R
(#3)
(#2)
INLET
CONTROL
VALVE WITH
TEFLON TAPE
III. DIRECTIONS FOR USE
GENERAL
Before using your chlorinator, your pool/spa water should
be properly balanced and conditioned and should have a
chlorine residual of approximately 1.0 to 1.5 ppm. Follow
dealer and chemical manufacturer's directions and
instructions.
Check chlorine residual daily and adjust the dial valve for
more or less chlorine. the chlorine demand for pools and
spas varies based on usage, temperature, sunlight, etc.
Initially, you'll have to experiment to determine the propr
amount of chlorine and the correct valve setting required
for your pool and filter time cycle. Follow chemical
manufacturer's instructions for proper chlorine level.
2
(#1)
COVER
O-RING
STRAINER
CHECK VALVE WITH
TEFLON TAPE
OUTLET
DRAIN
FIGURE II