Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Guide
Read these safety instructions carefully before use and
follow precautions for your safety.
Precautions in installation and
power connection
To prevent fire, electric shock or leakage.
Never install the refrigerator on a wet, watery floor or
where water can gather easily.
Check the following before power connection.
Connect power plug only to a grounded wall socket
(an earthed mains).
Do not plug refrigerator power together with other
appliances to the same socket.
Do not use an adapter plug or an extension cord.
Do not let the power cord be crushed by other
(heavy) objects.
If you hear a strange noise, strong chemical odour
or find smoke etc. from the refrigerator after the power
is plugged in, pull out the plug immediately and call
a service agent.
Wait about 5 minutes before you plug-in again in
order to prevent any damage to the compressor and
electrical devices of the refrigerator.
Wait 2~3 hours until the inside gets cold enough after
the first power plug-in, then store foods inside.
(There can be some smell of plastic parts on initial
operation of the refrigerator after plugging in.
The smell fades away as the refrigerator works and
doors are opened and closed.)
Precautions in use
To prevent personal injury, fire, electric shock etc. read
this user guide carefully before use and keep it at
hand for reference.
Accessories
Dispenser models only
Before use...
* After final installation and door leveling, put the pocket back
in its place and install the fridge door handles.
Installing freezer pockets
Installing door handles
Note : Both handles are installed in the same way.
•
Position one of the fridge door handles into the guides on
the fridge door, the set screws on the handle needs to point
to the center of the fridge freezer.
•
Using the supplied hex key tighten the two set screws (turn
in a clockwise direction).
•
Repeat this process for the other fridge door handle.
3
Publicité
Chapitres
Table des Matières
