System Presentation; General; Front Control Panel - Selco GENESIS 1700 TLH Manuel D'instructions

Connection for TIG welding
- Connect the gas hose from the cylinder to the rear gas con-
nection (1).
System for automation and robotics
- Connect the CAN-BUS signal cable for the control of external
devices (such as RC, RI...) to the appropriate connector (1).
- Insert the connector and rotate the ring nut clockwise until
the parts are properly secured.
Digital inputs (RI100)
- START
- GAS TEST
- EMERGENCY
Analog inputs (RI100)
- Welding current
Digital outputs (RI100)
- Welding tool ready
- Arc on
- Gas cycle
"Consult the instruction manual (RI100)".

3 SYSTEM PRESENTATION

3.1 General

These constant current inverter power sources are able to per-
form the following types of welding with excellent results:
- MMA
- TIG with remote arc striking by high frequency (TIG HF-
START) and control of the gas supply by the torch button
- TIG with contact ignition with reduction of short circuit cur-
rent (TIG LIFT-START) and control of gas delivery by means of
torch button (selectable from set-up).
In inverter welders, the output current is unaffected by va-ria-
tions in the supply voltage and the length of the arc, and is
perfectly levelled, giving the best welding quality.
The generator is equipped with:
- positive (+) and negative (-) socket
- a front control panel
- a rear panel
- a fitting for the torch button connector
- a gas socket for the torch
- a gas coupling on the rear side of the welding power source
for the connection with the gas cylinder
- a rear connector for remote control.

3.2 Front control panel

1 Power supply
Indicates that the equipment is connected to the mains
and is on.
2 General alarm
Indicates the possible intervention of protection devices
such as the temperature protection.
3 Power on
Indicates the presence of voltage on the equipment
outlet connections.
4 Welding methods
Allows the functions and the parameters management
in both manual and robot welding.
Manual welding
Robot welding
25