Maintenance Instructions - Osprey SOELDEN PRO Mode D'emploi

MAINTENANCE INSTRUCTIONS

8
REGULAR CHECKS
Your OSPREY ALPRIDE avalanche backpack requires no maintenance but the following points must be observed:
+ Deploy the airbag before the new season starts or at least once a year or after the backpack has been exposed to moisture / wet weather.
Check its condition, allow it to dry and fold it back together again.
+ Pack the airbag away only when it is completely dry.
+ Prior to every tour, check all the points described in this owner's manual and inspect the condition of the system's safety straps and
fastenings.
Practice deploying the airbag so you have a feel for the amount of force you need to apply. In the event of a real avalanche, you will then be
able to deploy it correctly and intuitively.
POST-AVALANCHE CHECK
Every use of the OSPREY ALPRIDE E1 AIRBAG SYSTEM can negatively affect the material. Often the damage is not visible with the naked eye.
After use in an avalanche, contact ALPRIDE.
OSPREY ALPRIDE E1 AIRBAG SYSTEM for further inspection.
If you are unable to send the ALPRIDE E1 AIRBAG SYSTEM, the following is recommended:
+ Check the airbag visually for punctures.
+ Check the airbag fastening straps for tears.
+ Check the shoulder, waist and chest straps as well as the seams for tears.
+ Check all buckles (adjustment buckles at the shoulder straps, waist and chest strap).
+ Check buckles as well as leg straps for tears and deformation.
HOW TO REMOVE THE DETACHABLE AIRBAG SYSTEM
1 2
1 Turn off the system, open the air bag zipper and detach the hooks.
2
Open the backpack, the compressor cover and the shoulder strap pocket. Detach the trigger handle.
3 Push the trigger handle and the cable through the hole. Open the hook and loop slot.
4 Pull the compressor and the airbag out.
OSPREY / ALPRIDE E1 AIRBAG SYSTEM | Owners Manual
3 4
HOW TO INSTALL THE DETACHABLE AIRBAG SYSTEM
1 2
1 Open the airbag compartment zipper 3 cm to the end.
2
Put the trigger handle through the hook and loop slot and insert it into the shoulder strap pocket.
Pass the airbag through the two holes into the airbag compartment.
3 Close the compressor compartment cover and attach the hooks.
4
Fold the airbag (see section 6) Attach the trigger handle (see section 7)
STORAGE, CLEANING & SERVICE LIFE
STORAGE
Store your OSPREY ALPRIDE E1 AIRBAG SYSTEM in a cool, dry environment. For safety reasons, keep the backpack out of the reach of
children. Osprey Packs, Inc. shall not be liable for any damages and losses due to improper storage.
CLEANING
Use only water (no cleaning products) to clean the backpack. Ensure that the entire product is dry before using it again to avoid the risk
of icing. In case of a dirty inflator, the inflator system must be cleaned properly with a damp soft microfiber towel. Damage may occur if
water comes into contact with the compressor motor. Alpride SA shall not be liable for any damages and losses due to improper cleaning.
DISPOSAL
Dispose of the product in domestic waste. Do not mechanically disrupt or incinerate the product. This may lead to potential hazards.
Electrical appliance:
+ Never dispose of the electrical appliance in your household waste.
+ Return the electrical appliance using the recycling facilities provided.
+ Contact your local waste disposal authority for more details.
AA/LR6 1.5 V Batteries:
+ Never dispose of batteries in your household waste.
+ They may contain toxic heavy metals and are subject to hazardous waste regulations.
+ The chemical symbols of the heavy metals are: Cd = cadmium, Hg = mercury, Pb = lead.
+ Only dispose of batteries when they are fully discharged.
+ Before disposing of the appliance, it is essential to first remove the batteries.
+ Return batteries using the recycling facilities provided.
+ Contact your local waste disposal authority for more details.
SERVICE LIFE
The product has a limited life time and should be replaced in case of signs of mechanical wear. It is recommended to regularly check your
gear and to replace it at least every five years after the first use. The functioning could be reduced due to mechanical wear or improper use.
Dispose of the product if you notice any damage. The OSPREY ALPRIDE E1 AIRBAG SYSTEM is designed to withstand 50 inflations.
3 4
English | 17