Other Features; Auto Standby - Ruark Audio MR1 Guide De L'utilisateur

Clearing the pairing list
Press and hold the Bluetooth button (22) on the remote
control for 5 seconds to clear all pairing information.
The status indicator (9) flashes when your MR1s are
ready to pair again.
You may also need to unpair or forget the "Ruark MR1"
entry in your device's Bluetooth pairing list.
Auto connect
Your MR1s will automatically attempt to connect to
the most recently paired Bluetooth device available. If
your preferred device does not auto connect, clear the
pairing list and pair it again.
For useful hints and tips on Bluetooth, please visit www.
ruarkaudio.com

7 Other features

Auto standby

Your MR1 speakers will automatically go to standby
after 10 minutes without an audio signal and they will
then turn back on as soon as a signal is detected.
Auto standby is on by default. To disable it select Line-
in mode and press and hold the Line-in button (20) on
the remote control for at least 5 seconds until the status
indicator (9) flashes twice.
To enable auto standby, select Line-in mode and press
and hold the Line-in button (20) on the remote control
for at least 5 seconds until the status indicator (9)
flashes three times.
Mute
Press Mute (19) on the remote. Press again to restore
volume to the previous level.
BackPack battery pack
Your MR1s are fully compatible with the R1 BackPack
battery pack so you can use them where mains power
is not available. See www.ruarkaudio.com
EN
DA
DE
FR
IT
ES
NL
NO
9