L.S. BILODEAU AirBilo Manuel De Fonctionnement Et D'installation page 43

ELECTRICAL CONNECTION OF OTHER COMPONENTS (do as in step 62 to fix the wires)
Step 76:
Connect the burner at the indicated location BRULEUR /
BURNER on the vent box.
.
Step 78:
Connect the wire from back of pellet hopper at indicated
location SÉCURITÉ GRANULES / PELLETS SAFETY on
the vent box.
Step 80:
Reconnect the chimney probe wire with the second
wire of the electronic fan limit.
Step 83:
Connect the pellet motor temperature probe sensor
wire to the back of the pellet hopper.
L.S. Bilodeau inc.
281 Route 108 Est, Saint-Éphrem-de-Beauce, Quebec G0M 1R0
Tel.: 418 484-2013 ▪ Fax: 418 484-2014 ▪
Step 77:
Connect the smoke evacuator on the vent box at
indicated location ÉVACUATEUR FUMÉE / SMOKE
EXTRACTOR.
Step 79:
Connect the auger motor on the vent box where indicated
MOTEUR GRANULE / PELLETS MOTOR.
Step 81:
Connect the burner overpressure
"Molex" together.
Step 84:
See instructions in the
individual guide supplied with
the furnace for the installation
and connection of the damper
actuator.
www.lsbilodeau.com
Step 82:
Proceed in the same
way as the previous
steps to fix the wires
to the furnace.
page 42